GE Capital 24959 Universal Remote User Manual


 
14
This feature assists you in identifying where your
original remote’s IR transmitter is located and
is particularly useful if your original remote’s IR
transmitter is hidden behind a lens.
1. Point both remotes facing each other by
approximately 1 inch apart (see Tips on
Learning on previous pages).
2. Press and hold the SETUP button until the red
indicator turns on, then release the button.
3. Press and release the desired Mode button (TV,
DVD, etc.), the red indicator blinks then stays
on.
4. Press and release the LEARN button, the red
indicator blinks then stays on.
5. Press and hold any Original Remote button
and move the Original Remote to the left
and right, and/or, up and down in front of
the Learning remote IR transmitter. The
red indicator will remain on if no IR from the
Original remote is found and the red indicator
will blink on and off more rapidly when the IR
transmitters are lining up. The point where the
red indicator blinks most rapidly is where the
two IR transmitters are aligned. Note some
original remotes will only transmit IR on the
initial button press then stop. In these cases,
quickly press and release the original remote
button repeatedly during this procedure.
6. You can now learn a button from your original
remote by continuing from “Step 4” in the
Learning Commands” section on the next
page, or, to exit at this point, press and release
the SETUP button
IR Transmitter Finder