GE Capital 24959 Universal Remote User Manual


 
7
Direct Code Entry
Direct Code Entry
NOTE: You can store any kind of code under any
mode (except TV). I.E. you can store a VCR code
under the CBL button, or a DVD code under the
AUX button, etc. However, you can only store TV
codes under the TV button.
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP
button.
2. Press and release the desired mode button
(TV, DVD, etc.). The red indicator blinks, then
stays lit.
3. Enter the 4 digit code from the code tables (on
separate sheet). Note: after a valid code entry,
the red indicator turns off. For an invalid code,
the red indicator ashes.
4. With your device on, press CHANNEL UP (or
POWER). If the device responds, no further
programming is required. Note: If some buttons
do not operate your equipment, try one of the
other codes for your brand.
Write your codes down here for easy reference
later.
Type Type stored Code
TV TV
AMP
DVD
SAT
DVR
VCR
CBL
AUX