GE Capital 24959 Universal Remote User Manual


 
15
tv
learn
setup
aspect
amp
aux
cbl
dvr
dvd
sat vcr
light
page
page
no yes
1. Press and hold the SETUP button until the red
indicator turns on, then release the button.
2. Press and release the desired mode button
(TV, DVD, etc.), the red indicator blinks then
stays on.
3. Press and release the LEARN button, the red
indicator blinks then stays on.
4. Press and release the Learning Remote button
that you want to teach (e.g. POWER).
5. Point both remotes facing each other by ap-
proximately 1 inch apart (see tips on page 12).
6. Press and hold the Original Remote button
(e.g. Power) until the red indicator blinks once
and stays on. If there is a learning problem, the
indicator blinks for three seconds and stays on.
If this happens, repeat Steps 4 to 6.
7. Repeat Steps 4-6 for other buttons you want to
learn.
8. Press and release the SETUP button when all
desired remote commands are learned. Code
Learning is now complete.
Learning Commands
Line up your remotes (that you’re learning from)
in front of the learning remote on a hard surface
approx. 1-inch apart.
2.
4.
3.
6.
1.
0
8
7
9
+100
enter