Filter
Top Products
10
DIP SWITCH CONFIGURATION
DIP 1 - EDID Mode
• OFF - Local EDID
When Local EDID mode is used, the EDID will be assembled by copying
all video and audio features of the connected device. Deep Color support
will be manually controlled: If Deep Color is supported by the display(s),
DIP 2 should be set to the ON position (see DIP 2 - Deep Color, below). By
default, the unit is shipped with DIP 1 in the OFF position.
• ON - Pass-Through EDID
Allows all video and audio features of the connected devices to be passed to
the source device without control over Deep Color.
DIP 2* - Deep Color
NOTE: DIP switch 2 is only functional when DIP switch 1 is set to the OFF posi-
tion.
• OFF - Enables Deep Color support (12-bit color)
Enables Deep Color support. In Pass-through EDID Mode, setting DIP2 =
OFF has no effect since all EDID information is passed through.
• ON - Forces 8-bit Color
Disables Deep Color in the EDID. Deep Color management is only available
when Local EDID is being used.
DIP 3 - Calibration Mode
• OFF - Enables Calibration Mode
Enables Calibration Mode. Make sure to set DIP switch 3 on both the
Sender Unit and Receiver Unit when calibrating the Extenders. See page 11
for details.
• ON - Calibration Mode Lock
Locks the calibration settings. Set DIP switch 3 on both the Sender Unit and
Receiver Unit to the ON position after the calibration process has completed.
See page 11 for details on the calibration process.