GoVideo HT2010 DVD VCR Combo User Manual


 
Rear Panel
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
VCR IN LINE 1 (AUDIO/VIDEO)
Connect to the audio/video output of an external
source (audio system, TV/monitor, another VCR, etc.).
ANT.IN
Connect the VHF/UHF/CATV antenna to
this terminal.
DVD/VCR OUT (AUDIO/VIDEO (Left/Right))
Connect to a TV with video and audio inputs.
AC Power Cord
Plug into a standard wall outlet.
S-VIDEO OUT (DVD OUT)
Connect to a TV with an S-Video Input. FOR DVD VIEWING ONLY.
DIGITAL AUDIO IN (OPTICAL)
Connect to the digital audio output of an external
digital device (see “Dust Protection Cap” below).
COMPONENT VIDEO OUT (Y Pb Pr) (DVD OUT)
Connect to a TV with Y Pb Pr inputs. FOR DVD
VIEWING ONLY.
RF OUT (DVD/VCR OUT)
Connect to a TV with an RF coaxial input.
VIDEO OUTPUT Switch
Select either S-VIDEO OUT or COMPONENT VIDEO OUT, depending on how
you connected the DVD+VCR to your TV.
AM Antenna Connectors
Connect the AM antenna to this terminal.
FM Antenna Connectors
Connect the FM antenna to this terminal.
SPEAKER Connectors
Connect the six supplied speakers to these terminals.
Dust Protection Cap
Remove the dust protection cap from the
DIGITAL AUDIO IN jack and connect the
optical digital cable (not supplied) securely
so that the configurations of both the cable
and the connector match. Keep the dust
protection cap and always reattach the cap
when not using the connector to protect
against dust intrusion.
10