Filter
Top Products
2-Button Interlock
6 312374J
2-Button Interlock
Attach Roller Switch and
Actuator
1. Attach roller switch (133) to bracket (132). Position
roller switch to far back position on the bracket and
leave mounting screws (144) loose.
2. Attach bracket (132) to ram with screws (105) and
washers (106). Leave screws loose. See F
IG
. 7 and
F
IG
. 8.
3. Raise platen to top of drum.
4. Attach actuator bracket.
a. For D200 and D200s supply systems: Attach
actuator bracket (138) near bottom of lift rod so
it engages the roller switch when the platen
reaches the top of the drum.
b. For D60 supply systems: Loosen one screw
(151a) and remove one screw (152b). Align
actuator rod (151) on piston rod so it touches
the air motor mounting bracket. Tighten actua-
tor rod to piston rod with four screws (140).
To reduce the risk of serious injury whenever you are
instructed to relieve the pressure, follow the Pressure
Relief Procedure, page 3.
F
IG
. 7: D200 and D200s Bracket
F
IG
. 8: D60 Bracket
ti10844a
133
132
144
105
106
144
132
105
133
106
r_289105_312375_5a
150
F
IG
. 9
F
IG
. 10
ti10848a
ti10847a
138
139
140
151b
139
152
153
140
138
r_289105_312375_5a
151a
151