Filter
Top Products
Operation
Haier LED HDTV EN-14
Play Fast forward
Pause Fast reverse
3.Playback speed.1x,2x,4x,8x,16x,32x.
4.Playback position. The playback position is always at
the center of the time bar.
5.Time scale, which shows the scales of every half hour.
The text would move smoothly as the time go by. And
the time scale text could be cut-o if the text is on the
boundary.
Note
Time Shift function is only available in DTVR
mode.
The maximum recording duration is determined R
bduration time can be calculated by the formula.
The timeshift record only supports FAT32 le-R
system.
The timeshift record supports more than 4GB R
recording. That is, the timeshift data is stored in
multi-le to resolve the FAT32 4 GB limitations.
The recording buer is a ring buer. For ring buer, R
if the maximum recording duration is reached,
the oldest program would be discarded and keep
recording the latest program.
When changing channel or changing input source, R
the timeshift would stop automatically.
Timeshift record will store the fact of no signal.R
Timeshift record will store the video, audio and R
data service. But because of the limited number of
PID lter in hardware, we only support:
Video streams: Max 1 stream
Audio streams: Max 8 streams
CC stream: No limited.
In recording, the data is not guaranteed to be R
stored in the disk. If the timeshift playback plays
a corrupted data block, it would show “Data lost”
message to indicate that the current data is not
stored correctly
Function Menu Options
Press A MENU button and CH+/- button until the
following menu appears on the screen.
Function
Language English
OSDTimeout Short
OSDTransparency Middle
DCR On
Blue Screen On
TimeSetup
Closed Caption
Default
Select
CH+/-
VOL+/-
Back
EXIT
Video
Audio
Channel
Lock
Function
DPMS On
Press B VOL+/ ENTER button to enter the menu and
CH+/- button to go up and down to select the
desired option.
Press
C VOL+/ ENTER button to conrm and VOL+/-
button increase and decrease the level to adjust the
selected option to your preference.
Repeat step 2 and step 3 until desired quality has
D
been achieved.
Function
LanguageY :Press VOL+/- button to select language of
the OSD.
OSD TimeoutY : Press VOL+/- button to select Middle
/Short and Long to change thetime of the OSD
display.
OSD TransparencyY : Press VOL+/- button to select
among Low/High and Middle to change the
transparency of the OSD. To select Low, the OSD is
opacity.
DPMSY : PC Power Management. To set On, the set
will be in standby mode automatically if no signal
in 2 minutes; if signal input , the set will be on again
automatically.
Blue Screen: Y Press VOL+/- button to select On, the
screen will be in blue after 3 seconds if there is no
signal.
DCR:Y Press VOL+/- button to select On or O.
Time Setup: Y Press VOL+/ ENTER button to enter the
submenu.
Time Zone: q Press VOL+/- button to select the
appropriate time zone.
Time Setup
TimeZone
Date/Time
SleepTimer Off
Select
Back
EXIT
Video
Audio
Channel
Lock
Function
CH+/-
VOL+/-
Date/Time: q Press VOL+/ ENTER button to enter
the submenu.