HP (Hewlett-Packard) f2304 Flat Panel Television User Manual


 
A–6 User’s Guide
Specifications
To locate defective pixels, the monitor should be viewed
under normal operating conditions and in normal operating
mode at a supported resolution and refresh rate, from a
distance of approximately 16 inches (50 cm).
HP expects that, over time, the industry will continue to
improve its ability to produce displays with fewer cosmetic
imperfections and HP will adjust guidelines as improvements
are made.
Entering User Modes
The video controller signal may occasionally call for a mode
that is not preset if:
You are not using a Hewlett-Packard standard graphics
adapter.
You are not using a preset mode.
If this occurs, you may need to readjust the parameters of the
monitor screen by using the on-screen display. Your changes
can be made to any or all of these modes and saved in
memory. The monitor automatically stores the new setting,
then recognizes the new mode just as it does a preset mode.
In addition to the 24 factory preset modes, there are four
user modes that can be entered and stored.