Filter
Top Products
HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
28
buttons.
Channel selection may also be performed by pressing CH up ( ) or down ( ).
You may also use these buttons for QUICK LIST. Press and hold the CH up (
) or
down ( ) button and a window will appear, allowing you to choose the channel you
wish to tune. Release the CH (
) or ( ) button when the channel you wish to tune is
highlighted, and the TV will tune to that channel.
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL
SOURCE mode. (See page 35.)
7 INPUT button
The INPUT button will select between both antenna signals and the three sets of video
input jacks each time the button is pressed. If the Picture-in-Picture is on, the INPUT
button will select between the three sets of video input jacks and both antenna sources
when main channel is chosen with the PIP CH button. IF the sub-picture is chosen, the
INPUT button will select between the three sets of video input jacks and the ANT A
antenna source (ANT B source cannot be displayed as a PIP Sub-Picture.)
NOTE: When ANT A is selected, the channel number in the upper right corner of the
screen is in green. When ANT B is selected, the channel number is in yellow.
8 VOLUME, MUTE buttons
Press the "VOLUME" up (
) or down ( ) button until you obtain the desired sound
level.
To turn the sound off instantly to answer the telephone, etc., press the "MUTE" button.
Press the "MUTE" button again or press the "VOLUME" up ( ) button to restore the
sound.