Filter
Top Products
Programming the Remote
- 16 -
PROGRAMMING THE REMOTE
DVD/VCR Functions
This remote is designed to operate different brands of DVD
players and VCRs. You must first program the remote to
match the remote system of your DVD or VCR.
Procedure
1. Turn ON your DVD or VCR.
2. Aim the remote control at the front of your DVD or
VCR.
3. While holding down the DVD/VCR button on the
remote, enter the 2-digit preset code that matches
your DVD or VCR. (See “Component Codes” on
page 17) The remote will turn off your DVD or VCR
when the correct 2 digit preset code is entered.
When this occurs, the remote control is
programmed for your DVD or VCR. If the DVD or
VCR does not turn off after 25 seconds, try a
different code, if available.
4. The remote will now control your DVD or VCR.
Notes
• If your DVD or VCR will not operate remotely
after performing the above procedures, this
means that your equipment’s code has not
been coded into the remote. Please consult
your equipment’s operating guide.
• The remote control will remember the codes
you have programmed in until the batteries
are removed from the remote control. After
replacing the batteries repeat the
programming procedure stated above.
• If your VCR does not have a remote power
function, the remote will issue the CHANNEL
UP function.
•The MENU button will act as the VCR MENU
button for HITACHI VCRs.
•The INPUT button will act as your VCR +100
button, if required.
Cable/Satellite Box Functions
This remote is designed to operate different brands of
cable boxes and Satellite boxes. You must first program the
remote to match the remote system in your cable/satellite
box.
Procedure
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/
satellite box.
3. While holding down the CABLE button on the
remote, enter the 2 digit preset code (See
“Component Codes” on page 17) that matches
your cable/satellite box. The remote will turn off
your cable/satellite box when the correct 2 digit
code is entered. When this occurs, the remote
control is programmed for your cable/satellite box.
If the cable/satellite box does not turn off after 5
seconds, try another 2 digit preset code, if
available.
4. The remote will now control your cable/satellite
box.
Notes
• If your cable/satellite box will not operate
remotely after performing the above
procedures, this means that your cable/
satellite box code has not been coded into the
remote. Please consult your cable/satellite
box operating guide.
• The remote control will remember the codes
you have programmed in until the batteries
are removed from the remote control. After
replacing the batteries, repeat the entire
programming procedure stated above.
• If your cable/satellite box does not have a
remote power function, the remote will issue
the CHANNEL UP function.
Write the code numbers from tables in this space. This will serve as a reference
if you need to program your remote control.
CABLE/SATELLITE BOX DVD VCR
0348E3.fm Page 16 Tuesday, April 25, 2000 4:15 PM