Filter
Top Products
AV NETWORK SETUP WIZARD
20
HITACHI AV NET SET UP
Proper Code Entered
from page 21.
AV Receiver
PV Recorder
VCR
DVD
Move
POWER MENU MORE
INFO
Device Setting
DVD
Device Code - - - -
(Enter code “9999” to uninstall)
Video Input No Connection
Audio Input No Connection
Transmission Test POWER PLAY CH UP
BACK OK EXIT
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input No Connection
Audio Input No Connection
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Congratulations
Your DVD is now
connected to your AV network.
HITACHI AV NET SETTING LIST
Device Code Video Audio
DVD 0672 INPUT 1 Using TV
VCR ---- Not Setup Not Setup
PVR ---- Not Setup Not Setup
AVR ---- Not Setup Not Setup
CBL ---- Not Setup Not Setup
STB ---- Not Setup Not Setup
Custom ---- Not Setup Not Setup
EXIT
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input Input 1
Audio Input Using TV
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Move
SEL Select
Set Input
AV Receiver
PV Recorder
VCR
DVD
POWER MENU MORE
Move
INFO
Device Setting
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input Input 1
Audio Input No Connection
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Move
SEL Select
Set Input
HITACHI AV NET SET UP
DVD
Device Code 0 6 7 2
(Enter code “9999” to uninstall)
Video Input Input 1
Audio Input Using TV
Transmission Test POWER PLAY CH UP
BACK OK EXIT
Move
SEL Select
Set Input
HITACHI AV NET SET UP
SEL
Select
Move
0-9
Input
Move
0-9
Input
THUMB
STICK
THUMB
STICK
THUMB
STICK
THUMB
STICK
SELECT
THUMB
STICK
SELECT
THUMB
STICK
(x2)
90
5. Follow the steps below to setup your AV network (See page 21 for AV Network Codes).
There are six steps in the setup procedure (DVD setup example below).
6. To uninstall or change device (equipment), press INFO button on the remote control when the device (DVD, VCR, etc.) is
highlighted.
7. See Remote Control AV NET button usage on pages 27 and 28.
FIRST TIME USE
Enter the device (equipment) code listed on page 21.
Use THUMBSTICK ̈ to select the input that the device (equipment)
is hooked-up to.
Transmission test for the device to confirm that the proper code was
set, by selecting (POWER, PLAY, etc.) soft keys shown. If the device
responds to the transmission test soft key, then it is properly set up.
Select OK to continue.