Hitachi 32HDT50 Flat Panel Television User Manual


 
ACCESSORIES
4
1. Remote Control Unit CLU-5726TSI (P# HL01826). 7. Speaker Accessories (50” only) (P#GM01232).
2. Two “AA” size, 1.5V batteries (P# FQ00021). 8. Wall Mount Unit WM50 (Optional) (P#QX00563).
3. Power Cord: 9. 32” Stand (SPD32 P# H520441) (Optional).
42” Stand (SPD42 P# H520442) (Optional).
10. 50” Table Top Stand (50STD3) (P#QD35632).
4. Monitor Connection Cable (P#EW07883). 11. Sub Woofer Cable (P# VZ11701).
5. Two IR Mouse cables (P# EY01641). 12. Cleaning Cloth (P#MS00803).
6. Speaker Accessories (42” only) (P#GM01193). 13. AVC Stand Accessories (P#QJ01081).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new “AA” size batteries for the remote control. When replacing
old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
BOTTOM VIEW
Lift up on tab to
remove back cover.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
CAUTION: 1. The plasma display wall mount unit WM50 is for use only with Hitachi model 32HDT50, 42HDT50 and
50HDT50.
2. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate
ventilation for the electronics or proper support for the front glass panel. This plasma television product is
designed for a maximum tilting angle of 45 degrees from vertical.
3. This SPD32 PDP stand for use only with Hitachi 32HDT50. Use with other apparatus is capable of resulting
in instability causing possible injury.
4. This SPD42 PDP stand for use only with Hitachi 42HDT50. Use with other apparatus is capable of resulting
in instability causing possible injury.
5. This 50STD3 stand for use only with Hitachi 50HDT50. Use with other apparatus is capable of resulting in
instability causing possible injury. See important marking located on bottom of stand.
POWER
TV
VCR
CBL
DVD
1
2
4
56
3
7
89
0
INFOSLEEP
A/V NET
EXIT
MENU
CHVOL
MUTE
PIP SURF
SWAP
FREEZE
PIP MODE
PIP ACCESS
DAY/NIGHT
SOURCE WIZARD
REC
SELECT
TV/RGB
ASPECT
STB
ANT
L
A
S
T
C
H
VID 1
V
I
D
2
VID 3
VID 4
VID 5
PVR
CD
AMP
VIDEO
REMOTE BATTERIES POWER CORD MONITOR IR MOUSE
CONTROL CONNECTION CABLE CABLE
3. 4. 5.
SPEAKER ACCESSORIES
(42”)
1.
WALL MOUNT UNIT WM50
(OPTIONAL)
PDP TV STAND (OPTIONAL)
32” (SPD32 P#H520441)
42” (SPD42 P#H520442)
8.
9.
50STD3 Table Top Stand
10.
2.
SPEAKER ACCESSORIES
(50”)
6.
7.
Subwoofer Cable
11.
AVC Stand
Accessories
12. 13.
Cleaning Cloth
Check to make sure you have the following accessories before disposing of the packing material.
FIRST TIME USE
32”/42” 50”
Plasma Monitor EV01841 EV01861
AVC EV01841 EV01841