Filter
Top Products
46
Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD ̆, ̄ or CHANNEL WHEEL to
highlight function
2. Press the SELECT button or CURSOR PAD ̈ to
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
1. Use the CURSOR PAD
̆ or ̄ or CHANNEL WHEEL
to highlight CABLE or AIR.
2. Press the CURSOR PAD
̇ or ̈ to highlight the
START or CLEAR option.
3. Press the SELECT button to start AUTO CHANNEL
SCAN.
NOTE: 1. When a CableCARD is installed, Auto
Channel Scan will not be available since
channels will be fixed based on what was
agreed upon by you and your cable
operator.
2. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons ̇ or ̈.
On-Screen Display
Channel Manager
Setup
Timers
Locks
Channel Manager
Audio
Video
Move SEL Select
Power Swivel
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move
SEL Select
or
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move
SEL Select
Signal Meter
Channel Manager
Move SEL Return
Channel 3-
Strength 1
Peak 1
Close
or
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Move
SEL Select
Auto Channel Scan
Channel Manager
Move SEL Return
Cable
Auto Channel Scan Start Reset
Cable Source Cable(1)
Air
Auto Channel Scan Start Reset
or