Hitachi 50SX7P Projection Television User Manual


 
USING THE REMOTE TO CONTROL VCR FUNCTIONS - 25 -
CAUTION: A pattern burn may develop if the sub-picture is left in the same corner
permanently. If the PIP feature is used frequently, occasionally shift the sub-picture to a
different corner.
NOTE:
1. Only sound from the main picture can be heard, unless you choose PIP from wireless
mode and use the
"TRANSMITTER OUT" outputs on the rear panel. (See page 44.)
2. Each strobe freeze frame is delayed about 0.3 (3/10) second.
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the pre-coded function for your VCR
This remote is designed to operate different types of VCRs. You must first program the
remote to match the remote system in your VCR. (Refer to page 26)
1. Set the MULTI-PAGE select switch to "VCR".
2. Turn ON your VCR.
3. Aim the remote control at the front of your VCR.
4. While holding down the VCR POWER button on the remote, enter the 2 digit preset
code that matches your VCR as shown on page 26. The remote will turn off your VCR
when the correct 2 digit preset code is entered. When this occurs, the remote control is
programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different
2 digit preset code.
5. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, this means that
your VCR's codes have not been precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above