Filter
Top Products
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
43
3. Press the CABLE (CBL) button on the remote to switch to cable mode.
4. Hold down the CBL button on the remote and enter the two digit preset code that matched your cable box as
shown on page 37. The indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when
the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable
box. If the cable box does not turn off, try a different two digit preset code.
6. The remote will now control your Cable box.
NOTES:
1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been
precoded into the remote.
2. In the unlikely event that your cable box cannot be operated after performing the above procedures, please
consult your cable box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. The LAST CH button will act as your cable box ENTER button if required.
5. The SLEEP button will act as your audio components '100' button if required.
6. The INPUT button will act at the TV/SAT button when in SAT mode.
(1) CABLE (CBL) Button
This button allows the remote to control your cable box by setting it to CABLE mode.
(2) PRECODED CABLE Box buttons