Filter
Top Products
PRESET FOR USE - 15 -
3 Select "TV STEREO" or "SAP"
Press CH
or button repeatedly to point to "TV STEREO" or "SAP.
Then, press SELECT button.
4 To return to TV mode
Press MENU button.
Notes:
• You must select the recording mode in TV STEREO or SAP when you record broadcast.
Refer to "MTS RECORDING/MONITOR MODE" on previous page.
When you play the tape on the VCR later, it will be in stereo or second audio.
• If you select second audio when second audio is not available, the VCR will record normal audio.
PRESET FOR USE
Channel memory programming is NOT needed when connected to a cable box. You can program the tuner to
scan only the channels you receive in your area. See page 34 for channel designations.
NOTE: You must use the remote control for this procedure.
AUTOMATIC CHANNEL PRESET (Without a Cable Box)
NOTES:
• Follow the steps below once. Repeat it only if there is a power failure or the VCR is unplugged for more than 30
seconds. (In these cases, the programmed channels are erased.)
• You must follow the steps below before attempting to play or record a video tape. If you want to play or record a
video tape. If you want to play or record a video tape BEFORE programming the tuner, you must first press the
POWER button to turn off the VCR. Then, press the POWER button again to turn it back on. To program the tuner
again, see "CHANNEL PRESET AGAIN".
1 Plug in the VCR power cord ("--:--" flashes)
Plug the VCR power cord into a standard AC outlet.