Filter
Top Products
SKIPPING UNWANTED SCENES DURING RECORDING
Press the PAUSE button on the remote control to temporarily stop recording.
Press the PAUSE or REC button to resume recording.
Press the PAUSE or REC button to resume recording.
PAUSE
n n n n n
NOTE: When the VCR is in the Pause mode, you may view the time remaining with n marks on the TV
screen. Each n mark represents one minute. After five minutes, the VCR will automatically switch to the
Stop mode to prevent tape damage. When there is 1 minute remaining, one n will flash.
RECORDING ONE PROGRAM AND VIEWING ANOTHER
You can record one program while viewing another. To start recording, follow steps [1] to [3] under
"VIEWING AND RECORDING THE SAME PROGRAM".
To select the channel you want to view at the TV, follow the steps below.
NOTE: If you have a cable box or satellite box connected to this VCR, please refer to
"ANTENNA/CABLE CONNECTIONS" on pages 11 and 12 before proceeding to the next step.
4 Select the TV mode
Press the VCR/TV button on the remote control so that the "VCR" indicator on the VCR's digital display
disappears
5 Select the channel on the TV
Set the TV to the channel you want to watch.
TO MONITOR THE PROGRESS OF YOUR RECORDING
1) Press the VCR/TV button on the remote control so that the "VCR" indicator on the display comes on.
2) Turn on the TV and set the TV channel to 3 or 4. Now set the CH3/CH4 switch on the back of the VCR
to match the channel selected on the TV.
.
IRT (Instant Recording Timer)
This function enables you to set the recording length simply by pressing the REC/IRT button on the VCR.
• Please refer to the connection you are using, through pages 10, 11, or 12 on "ANTENNA/CABLE
CONNECTIONS" before continuing.
• You cannot use the remote control for this function.
• Be sure to check that the "PWR." and the "VCR" indicators are both on.
• Turn on the TV and set the TV to channel 3 or 4. Now set the CH3/CH4 switch on the back of the VCR to
match the channel selected on the TV.
• Insert a cassette tape with its erase prevention tab in place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTE: If you have a cable box or satellite box connected to this VCR, please refer to
"ANTENNA/CABLE CONNECTIONS" on pages 11 and 12 before proceeding to the next step.
1 Select the channel to be recorded
Press the number buttons on the remote control or the CHANNEL(CH) or button.