Honeywell HD-DVR-1008 DVR User Manual


 
Overview of Navigation and Controls
42
Delay: When detected motion is completed, the system will continue
alarm output and recording for a specified time respectively. The value
ranges from 10-300(Unit: second).
Region: Click Select, the interface is shown as in Figure 4-16. Here
you can set the motion detection zone. There are 396(PAL)/330(NTSC)
small zones.
Sensitivity: The system supports 6 levels. The sixth level has the
highest sensitivity. The fifth or lower levels are recommended to avoid
setting a false alarm.
Show message: The system will send message to the local host screen
to alarm you if you have enabled this function.
Send email: The system can send out an email to alert you when the
alarm occurs.
PTZ activation: Here you can set PTZ movement (of any video
channels) such as going to a preset when motion is detected in the
current video channel. Click Select, and you can see an interface is
shown as in Figure 4-17.
Period: Click Set to determine the period for the channel to be armed
for motion detection. See the interface shown as in Figure 4-18. Here
you can set for business days and non-business days. In Figure 4-18,
click Set, and you will see an interface as shown in Figure 4-19. Here
you can set your own business day and non-business day.
Alarm output: After the motion detection has occurred, the system
enables the peripheral alarm devices.
Tour: Here you can enable the tour function when the alarm occurs. It
is a one-window tour. Please go to Display for tour interval setup.
Note
If there are record chan
nels selected, only the record
channels will be displayed in the tour.
Check boxes to select the corresponding function. After all the settings,
click Save, and the system will return to the previous menu.
Note
In Figure 4-16
, you can left click the mouse and drag it to
set a region for motion detection. Click Fn
to switch
between arm/withdraw motion detection. After setting the
region, click the enter button to exit.