Filter
Top Products
Netfinity EXP300 Type 3531 33
a. Verify the setting of the unit ID switch (sometimes referred to as a box ID or a
tray ID).
b. Locate the expansion unit ID labels that come with this kit; then, apply the
label that matches the setting for the unit ID in the blank label area directly
below the SCSI ID label.
3. Refer to “Turning the expansion unit on and off” on page 3 for information about
turning on the expansion unit.
Note: Important information for IBM ServeRAID users:
If you are using a ServeRAID software version earlier than Version 3.50, the
View Configuration screens might show SCSI IDs or bay numbers. If the data
shown on the View Configuration screen begins with '0', it denotes SCSI IDs.
If the data shown on the View Configuration screen begins with '1', it denotes
bay numbers.
Installing the EXP300 in a NetBAY enclosure
NetBAY enclosures are stackable and each can store a different device, such as the
EXP300 expansion unit. You also can attach a server to the top of the enclosure. Refer
to the NetBAY documentation for details on installing other devices.
Note: Because of the depth of the NetBAY3 enclosure, it might be difficult to set the
expansion unit option switches once installed. Verify that internal option
switches 1 and 2 are set to Off, and that internal option switch 3 and the Unit
ID dial ID switch are set properly for your environment (see “Setting the
interface options and ID settings” on page 10 for more information).
To install the expansion unit in the enclosure, use the following procedure:
1. Remove the rear of the enclosure 1.
2. Use the following illustration of the front and rear rack-mounting flanges to
determine the appropriate enclosure-mounting holes for installing cage nuts to
secure your device and rails. From left to right, the illustration shows the front
and rear flanges respectively.