Filter
Top Products
SCOM-100, User guide 30
The command to set an output after an initial delay is:
1020,m,n,h,mn
1020: Command ID
m: Module number (0 for SCOM-100 main
unit, 1-8 for DI-42 I/O expansion units)
n: Output number (1-4 for SCOM-100
main unit, 1-2 for DI-42 I/O expansion
units)
h: Delay on duration hours (0-21)
mn: Delay on duration minutes (0-59)
4.4.6 Resetting a digital output after a delay
A command is available to reset a digital output with an
initial delay time. The digital output’s switching behaviour
is shown on the time-based diagram below.