Insignia NS-19E450WA11 Flat Panel Television User Manual


 
5
Insignia 19"/22" LED-LCD HD TV
www.insigniaproducts.com
Install the stand or
wall-mount bracket
Installing the stand
To install the stand:
1 Carefully place your TV screen face-down on a
cushioned, clean surface to protect the screen
from damages and scratches.
2 Secure the stand to the screen with the three
provided screws.
Adjusting the viewing angle
To adjust the viewing angle:
Tilt the screen forward 5° or backward 10°.
Installing a wall-mount bracket
To attach your TV to a wall-mount bracket:
1 Carefully place your TV screen face-down on a
cushioned, clean surface to protect the screen
from damages and scratches.
2 Remove the two screws holding the TV to its
stand column.
3 Remove the stand column.
4 Secure the wall-mount bracket to the back of
your TV using the four M4 screws provided with
bracket.
TV components
Accessories
Remote control
Remote control holder
Batteries (2 AAA)
•Component cable
•Audio cable
Cleaning cloth
TV stand and screws
Quick Setup Guide
Front
Caution
When adjusting the viewing angle, be careful not to
tip over your TV.
Note
To avoid interference between the jacks, wall-mount
bracket, and wall, the wall-mount bracket must be
more than 40 mm thick, and the RF or VGA cable
must have a 90-degree plug.
-5
o
10
# Item Description
Remote control sensor Receives signals from the remote control. Do not block.
Power indicator
Lights blue when your TV is turned on.
Lights red when your TV is in standby mode.
Turns off when the power cord is unplugged.
1
2
1
2