Filter
Top Products
6
Insignia NS-F20C 20" Flat Tube TV
www.insignia-products.com
Installing remote control batteries
To install batteries in the remote control:
1 Remove the battery cover.
2 Insert two AAA batteries into the battery
compartment. Make sure that the + and –
symbols on the batteries match the + and –
marks inside the battery compartment.
3 Replace the battery cover.
Setting up your TV
Connecting an antenna or direct cable
To connect an antenna or direct cable:
1 Plug one end of a coaxial cable into your
antenna or cable wall jack.
2 Plug the other end of the cable into the
antenna jack on the back of your TV.
Connecting a cable or satellite receiver
To connect a cable converter box or satellite
receiver:
1 Connect a coaxial cable from your cable or
satellite signal source to the IN jack on cable
converter box or satellite receiver.
2 Plug a coaxial cable into the OUT jack on
your cable converter box or satellite receiver,
then plug the other end of the cable into the
antenna jack on the back of your TV.
Connecting a standard A/V device
Your TV has two set of standard A/V jacks. One
set is on the back of your TV. The other set is on
the left side of your TV.
To connect a standard A/V device to the back
A/V jacks:
1 Plug the video (yellow) connector on a
standard A/V cable into the video out jack on
the external device, then connect the other
video (yellow) connector into the VIDEO IN
jack on the back of your TV.
2 Plug the left audio (white) connector on a
standard A/V cable into the left audio out jack
on the external device, then connect the
other left audio (white) connector into the
AUDIO IN L (left) jack on the back of your
TV.
3 Plug the right audio (red) connector on a
standard A/V cable into the right audio jack
on the external device, then connect the
other right audio (red) connector into the
AUDIO IN R (right) jack on the back of your
TV.
Warning
Do not throw the batteries into fire. Dispose of
used batteries as hazardous waste.
Caution
Do not drop or disassemble the remote control. Do
not get the remote control wet.
Note
When the remote control will not be used for a
long period of time or when the batteries are worn
out, remove the batteries to prevent leakage.
VHF UHF
Mixer (not
included)
Antenna jack
Power cord
No. Component
1 DVD player
2VCR
3 AUDIO R OUT
4 AUDIO L OUT
5VIDEO OUT
6 VIDEO2 IN
7 AUDIO L IN
8 AUDIO R IN
1
2
3
4
5
6
7
8