Filter
Top Products
11
Insignia NS-LCD22 LCD TV
www.insignia-products.com
You can use the CH+/- buttons to cycle
among the viewable channels. Not viewable
channels are skipped.
Monitoring DTV signal strength
You can use the DTV signal strength monitor to
check how strong your DTV signal is, and then
determine if you need to adjust your antenna or
digital cable input. The higher the signal
strength, the less likely you are to experience
picture degradation.
To monitor DTV signal strength:
1 Press MENU.
2 Press or to select Setup menu, then
press ENTER or to access the submenu.
3 Press or to select DTV Signal, then
press ENTER or to view the on-screen
signal strength monitor and see the quality of
the signal being received.
Labeling channels
If a channel is not already labeled, you can label
the channel so you know what channel you are
watching.
To label your channels:
1 Press MENU.
2 Press or to select Setup menu, then
press ENTER or to access the submenu.
3 Press or to select Channel Labels,
then press ENTER or to view the Channel
Labels Menu.
4 Within the menu, press or to move the
highlight or cursor. Press or to select
the channel number, or select a character.
Press ENTER to return to the previous menu.
5 Press EXIT to return to watching the
television.
Selecting channels
You can use one of three methods to select a
channel:
• Use the number pad
• Use the CH+ and CH- buttons
• Use the previous channel button
Using the number pad
To go to a specific channel number:
• Press the number buttons (0-9) and the
dash (-) button, then wait for the television
to change channels, or press ENTER to
go immediately to that channel.
For example, if you want to select channel
8-3, press 8-3 on the remote control. (Make
sure that you press the buttons within three
seconds of each other, or the channel won’t
be entered correctly.)
Using the CH+ and CH- buttons
To browse through the channels:
• Press:
• CH+ to browse up the channels.
• CH- to browse down the channels.
Using the previous channel button
To switch between two channels:
• Press the previous channel button to
switch between the current channel and the
previous channel.
Information about USA channel numbering
• The ATSC PSIP channel uses a two part
channel number which includes:
• a major channel number
• a minor channel number
• In the US, in most locations the major
channel number is the same for both analog
and digital channels (It is equal to the NTSC
channel number for existing broadcasters.)
• In the US, a minor channel number of zero is
used for a broadcaster's analog channel.
Note
You can use the Manual Channel Set Menu to
select a channel you want to view.
Note
If a channel label is provided on the signal from
the broadcasting station, the television displays
the short name for the DTV channel, even if you
didn’t set up a label for that channel.
Note
In some situations, virtual channel numbers do not
correspond to physical frequencies.
Note
Example: Channel 5-1. The “5” is the major
channel number and the “1” is the minor channel
number.
NS-LCD22.fm Page 11 Monday, February 19, 2007 1:39 PM