Filter
Top Products
12
Insignia NS-P10DVD11 10” Portable DVD Player
www.insigniaproducts.com
Using your player
Playing a DVD or audio CD
To play a disc:
1 Make sure that your player is connected to power.
2 Slide the POWER switch to the ON position.
3 Slide the OPEN switch to the right. The disc tray opens. For the
location of the OPEN switch, see “Top” on page 7.
4 Place a disc, label side up, in the disc tray, then close the tray. The disc
starts playing automatically.
Controlling DVD or audio CD playback
To control disc playback:
• Press (STOP) once to stop playback. Your player remembers
where you stopped. If you press , your player starts playing
at the point where you stopped.
• Press (STOP) twice to stop playback. If you press , your
player starts playing at the beginning of the disc.
• Press to pause playback. Press this button again to resume
playback.
• Press on the remote control or press and hold (NEXT)
to fast-forward the disc. Each time you press this button, the
fast-forward speed changes from 2 to 4 to 8 to 16 to 32 times
the normal speed.
• Press to fast-reverse the disc. Each time you press this
button, the fast-reverse speed changes from 2 to 4 to 8 to 16 to
32 times the normal speed.
• Press (NEXT) to go to the next title, chapter, or track.
Notes
• Most DVDs and your player have region codes that help
control illegal distribution of DVDs. The region code for
your player is 1. You can only play DVDs with a region
code of 1 or ALL. The region code for a DVD is printed on
the DVD or the DVD packaging.
• In disc playback Pause/Stop or disc tray Open state, the
player will go to standby(power saving) mode if there is
no operation for about 5 minutes. To turn the player back
on, press any key on the remote control to activate.
Note
When playing an audio CD, press STOP once to stop
playback and return the player to the beginning of
the CD.
NS-P10DVD11_11-0590_MAN_V2_EN.fm Page 12 Tuesday, June 14, 2011 2:48 PM