Filter
Top Products
17
DPS-9.1 US_E 29343004
Before connecting the POWER
• The DPS-9.1 is shipped with the main power
(Power) switch in the on position (
On). When
the power cord is plugged in for the first time,
the DPS-9.1 will automatically enter the
standby state and the Standby indicator will
light (same condition after step 2 below).
• Make sure that all appropriate connections have been
completed as described on pages 10 to 13.
• Turning on the DVD Player may cause a momentary
power surge, which might interfere with other electrical
equipment such as computers. To prevent interference,
use a wall outlet on a different circuit.
Connecting the Power/
Turning on the DVD Player
Display
Video Circuit
O
f
f
PlayStopOpen
/Close
Standby/On
Standby
Power
On
O
f
f
96
/
88.248
/
44.1 192
/
176.4
Sampling Rate
(
@@
)
kHz
PROGRESSIVE
SCAN
1 Plug the supplied power cord into
the AC INLET and then into the
power outlet on the wall.
Notes
• Do not use a power cord other than the one supplied with the DPS-9.1. The
power cord supplied is designed for use with the DPS-9.1 and should not be
used with any other device.
• Never have the power cord disconnected from the DPS-9.1 while the other end
is plugged into the wall outlet. Doing so may cause an electric shock. Always
connect by plugging into the wall outlet last and disconnect by unplugging
from the wall outlet first.
2 Press Power to switch on the
main power.
The DVD Player enters standby mode.
The Standby indicator lights up.
Notes
• The buttons on the remote controller do not operate if the Power switch is set
to OFF.
• To switch off the main power, press Power again.
3 Press Standby/On on the DVD Player
or ON on the remote controller.
The DVD Player turns on and the Standby indicator turns off.
The first time you turn on the DVD Player, the Initial Setup screen
appears.
Press ENTER, then follow the procedure on page 54 to set up your DVD Player for
the first time.
Notes
• To put the DVD Player in the standby mode, press Standby/On on the DVD Player, or
STNBY (or ON) on the remote controller. Be sure to set the volume to minimum before
putting the DVD Player in the standby mode for the next use to avoid sudden loud sound
reproduction.
• While the Standby indicator lights up, the DVD Player can receive signals from the remote
controller. However, if you press Power on the DVD Player to switch off the main power, the
remote controller cannot be used to turn on the DVD Player.
• You can change the First Setup later with “Customizing the Function Settings” starting from
page 44.
• Setting the Standby button to standby does not shut off the power completely.
To a wall outlet
Power cord
(supplied)
AC INLET
DPS-9.1(US_E)p10-19.p65 10/11/00, 18:5717