54 Intel
®
Server System SR1500AL User’s Guide
10. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct”.
11. Install the server system cover. For instructions, see “Installing the System Cover”.
12. Plug all peripheral devices and the AC power cable(s) into the server.
Installing and Removing the I/O Expansion
Module(s)
Installing the I/O Expansion Module(s)
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover”.
4. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly”.
5. Squeeze the sides of the I/O expansion module cover(s) to disengage it from the
server system back panel and remove it. See letter “A” in the figure below.
6. Attach the standoffs to the server board (see letter “B” in the figure below) and
attach the I/O expansion module(s) to the server board (see letter “C” in the figure
below).
Figure 44. Installing the I/O Expansion Module to the Server Board
A
I/O Module
(External SAS)
I/O Module
(Dual Gigabit)
C
B
AF000746