Filter
Top Products
25
5.3.9. Upgrade RA & DEC
Use this operation to upgrade 8408 hand controller, R.A. and DEC motor controller firmware. Please
refer to iOptron online documents for ZEQ25 firmware upgrade details. The password is 9999.
5.4. Align
This function is used for aligning the telescope. The hand controller provides “Polar Align”, which
uses a set of 2 bright stars for polar alignment. This provides a viable polar alignment approach for those
who can’t see the polar star or has a mount does not equip an iOptron AccuAlign
TM
polar scope. The system
also provides three alignment methods: “SolarSys Align”, “One Star Align”, and “Multi-Star Align”. The
mount has to be at Zero Position before performing any star alignment.
5.4.1. Polar Alignment
Press the MENU button, then select “Align” and “Polar Align”. The HC will display the azimuth and
altitude position of several bright stars near meridian. Select one that is visible with high altitude as
Alignment Star A. Follow the HC instruction to move the Star A to the center of the eyepiece with the
combination of Latitude Adjustment Knob and “◄” or “►” button. Press ENTER to confirm. Next, select a
bright star that is close to the horizon as the Alignment Star B. Center it using the Azimuth Adjustment Knob
and “◄” or “►” button (The “
▲”
and “
▼”
buttons are not used here). Press ENTER to confirm.
The telescope will now slew back to Star A to repeat above steps. The iteration can be stopped
when it is determined that the alignment error is at the minimum. Press BACK button to exit alignment
procedure.
NOTE: It is highly recommended to use an eyepiece with crossed-hair line for accurate centering.
NOTE: The movement of the alignment star in your eyepiece may not be perpendicular but crossed,
depends on its location in the sky.
5.4.2. SolarSys Alignment
Press MENU button and select “Align”. Select “SolarSys Align” and press ENTER for available
alignment object.
5.4.3. One-Star Alignment
Press MENU button and select “Align”. Select “One Star Align” and press ENTER. A list of
alignment stars that are above the horizon is computed based on your local time and location. With the
mount at the “Zero Position,” use ▲ and ▼ buttons to select a star and press ENTER. Center the target in
your eyepiece using arrow key. Press ENTER when finished. If your mount is well set up and polar aligned,
one star alignment should be sufficient for good GOTO accuracy. To increase the accuracy you may
choose to do multi star alignment.
5.4.4. Multi-Star Alignment
With iOptron’s multi-star alignment, you can choose two, three, or as many stars as you want to
reduce the mount alignment offset.
Press MENU button and select “Align”. Select “Multi-Star Align” in the align menu. A list of
alignment stars that are above the horizon is computed based on your local time and location. With the
mount is at the “Zero Position,” use ▲ and ▼ buttons to select first alignment star and press ENTER.
Center the target in your eyepiece using arrow key. Press ENTER when finished. The hand controller will
prompt you to choose the second star. If the star you choose is too close to the first one, the system will let
you choose another one. When you are aligned with the second star, the two star alignment is finished. You
can reject the suggested star if it is blocked by a tree or other obstruction.