Filter
Top Products
Clear All Stored Learned Commands Under a
Mode
If you want to clear all of the Learning commands under one
mode, such as TV, VCR or DVD, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until
the LED indicator light remains on and the touchscreen
shows the Main Setup Screen. This process takes approxi-
mately 2-3 seconds.
2. Release the SETUP key.
3. Press and release the LCD LEARN key. The LED indicator
light blinks once to indicate acceptance of the keypress.
4. The touchscreen now shows the Device Setup Screen.
Press and release the device key on the rubber keypad for
the mode commands you want the RM24941 to clear (TV,
VCR, SAT/CBL, etc.). The LED indicator light blinks once
to indicate acceptance of the keypress.
5. The touchscreen now shows the Learn Setup Screen 1.
Press and hold the SETUP key until the Main Setup
Screen is displayed. All Learned commands that were pre-
viously stored under that mode are now cleared.
6. Press LCD CLEAR on the Main Setup Screen to exit
Setup Mode.
Master Clear
Clearing all stored Learned commands is recommended before first-time Learning. To clear
all Learned commands, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until the LED
indicator light remains on and the touchscreen shows the Main Setup Screen. This
process takes approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and hold the LCD LEARN key until the Main Setup Screen is displayed. This
process takes approximately 5 seconds.
4. All Learned command entries are now cleared for all device modes.
5. Press LCD CLEAR on the Main Setup Screen to exit Setup Mode.
11
24941manual 8/13/03 8/19/03 8:42 AM Page 13