Jasco RM24941 Universal Remote User Manual


 
Additional Features
Keypress Beep Feature
Your RM24941 beeps whenever a key is pressed to acknowledge the keypress. You can turn
this feature on or off. The default setting is On.
To turn the Keypress Beep on or off, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until the LED indicator light
remains on and the touchscreen shows the Main Setup Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and hold the MUTE key on the rubber keypad for approximately 5 seconds until
the LED blinks and the Main Setup Screen is displayed.
4. Press LCD CLEAR on the Main Setup Screen to exit Setup Mode.
5. The Keypress Beep feature is now turned on or off, depending on the previous state it
was in.
LCD Touchscreen Display Time
You can choose the length of time the touchscreen remains on after the last keypress. The
power-on default is 30 seconds from the last keypress. Setting the LCD Touchscreen Display
Time also changes the length of time the Backlight stays on, if activated.
To change the LCD Touchscreen Display Time, follow these steps:
1. Press and hold the SETUP key on the rubber keypad until the LED
indicator light remains on and the touchscreen shows the Main Setup
Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and release the SETUP key again. The LED indicator light blinks
to acknowledge the keypress and the Digit Setup Screen is shown.
4. Press and release a digit key (1-9) to indicate the length of time you
wish the touchscreen to remain on. (The RM24941 can only accept the
following options: 1=10 seconds; 2=20 seconds; 3=30 seconds, etc.)
Ninety seconds is the longest length of time allowable. The LED indica-
tor blinks once to acknowledge the keypress.
5. Press and release the LCD ENTER key to save the setting. The touch-
screen returns to the Main Setup Screen.
6. The LCD Touchscreen Display Time setting is now complete.
7. Press LCD CLEAR on the Main Setup Screen to exit Setup Mode.
14
24941manual 8/13/03 8/19/03 8:42 AM Page 16