Filter
Top Products
September 16, 2009 920394 Ethernet Interface Installation Page 3
e. The Port number will now appear as a five-digit
number. If you do not wish to change it, press ENTER.
If you do wish to change it, it must be entered as a five-
digit number. For instance, if you wish for port #80,
you must enter 00080. If a mistake is made, press the
CLEAR button once.
f. After the ENTER key is pressed this last time, the
changes will be made to internal non-volatile memory,
and a message will appear.
g. As the message indicates, the changes will not take
place until the power has been turned off and back on.
III. Operation
In operation, the MCS-3800, MCS-3400 or MCS-3000 with a
920394 Ethernet Interface Card behaves as a TCP server,
operating on the set IP address and port number. It is
necessary for a client to establish a TCP connection with the
MCS-3800, MCS-3400 or MCS-3000 before anything else can
take place. Once a connection has taken place, operating a
control will cause a packet to be sent to the client. A message
from the client will be reflected by fader position, LED state,
or LCD message on the MCS-3800, MCS-3400 or MCS-3000.
All messages within the TCP packet are the standard MCS-
3800, MCS-3400 or MCS-3000 messages as published in the
developer documents.