Filter
Top Products
This next screen shows the Test Unit
Ready Screen. If the unit is online
and ready, the dialog box will report
Target [x] Ready. If the unit is
offline, the dialog box will report
Target [x] Not Ready. 'x' is the
number of the target that was selected
previously and any commands that
are initiated will only affect that
target. To select a different device,
use the ESC key to back up a menu
and select it.
This next screen shows the Inquiry
Screen that is used to report
information on the device as read
from the device itself. Since this
information is from the device, the
information will vary. The Product
ID typically shows a model number
of the device and the Product
Revision Level will typically show
the firmware revision the device is
currently using. The other
information on this screen applies
only under circumstances when
troubleshooting is necessary.
This screen shows the Read
Capacity Screen which reports the
capacity settings and configuration of
the target device.
FORTRA
H1 Chaparral G5312 Installation Guide Rev C
9-4