Filter
Top Products
The Power Supply Ena/Dis Screen,
allows each power supply to be
turned off (disable), or turned on
(enable). From the rear of the unit,
power supply 1 is on the left hand
side, and power supply two is on
the right hand side.
The Fan Setup Screen, allows for
manual control of the blowers.
Individual blower control is not
available so using these commands
will set both blowers at the same
time.
The SCSI ID Setup Screen, allows each slot ID to be changed on-the-fly. Any
changes to these settings will be saved to the unit upon exiting the program. SCSI
ID's can be viewed using the Enclosure Status menu. This menu screen has two
submenus; on the first submenu, the slot must be selected as shown on the left
screen. On the second submenu, the new ID for the selected slot must be chosen.
Use the ESC key to back out of the menu if an incorrect choice is selected. After
changing the ID, go to the Enclosure Status menu to ensure that it has been
changed successfully.
FORTRA
H1 Chaparral G5312 Installation Guide Rev C
9-9