Filter
Top Products
June 30, 2003 6:18 pm Page 12
— 12 —
Master Page: Right
F
Enter channel position
Press PR +/–.
G
Set tape speed
Press p to set the tape speed.
H
Access title edit screen
Press the number keys “1”. The Title Edit
screen appears.
● You can access the Title Edit screen
only when “PROG. NAVIGATION” is
set to “ON”. (
੬
16)
I
Enter programme title
Press the number keys and PUSH JOG e
to enter characters, then press OK. For
details, refer to “Entering character” on
page 15.
J
Return to normal screen
After confirming all information is
correct, press PROG or OK. “PROGRAM COMPLETED” appears
on the screen for about 5 seconds, then normal screen appears. If
“PROGRAM OVERLAPPED” appears on the screen, see page 13.
● Repeat steps 1 – 10 for each additional programme.
K
Engage recorder’s timer mode
Press #. The recorder turns off automatically and “#” appears on
the display panel.
● To disengage the timer, press # again.
NOTES:
● To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 10, press WEEKLY (number
key “9”) for weekly serials or DAILY (number key “8”) for daily
serials (Monday – Friday). Either “WEEKLY” or “DAILY” appears
on the screen. Pressing the button again makes the
corresponding indication disappear.
● You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “PROGRAM FULL” appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
੬
13).
● In case of a power failure after programming, the recorder’s
memory backup keeps your selections (if the lithium battery is
not exhausted).
24H Express Timer Programming
You can programme a timer recording that starts within 24 hours.
A
Access 24HR Express Timer Programme display
Push 24H EXPRESS #. “” and start time start blinking on the
display panel.
B
Set programme start time
Turn the JOG dial to the left or right. Then, push the JOG dial.
“” and start time start blinking on the display panel.
● One click stop of the JOG dial changes the time in 5-minute
intervals.
C
Set programme stop time
Turn the JOG dial to the left or right. Then, push the JOG dial and
channel number will start blinking.
● One click stop of the JOG dial changes the time in 5-minute
intervals.
D
Set channel position
Turn the JOG dial to the left or right. Then, push the JOG dial and
channel number will start blinking.
● You can cancel the setting at any time by pressing and holding
the JOG dial for more than 3 seconds. Repeat from the step 2.
E
Engage recorder’s timer mode
Press 24H EXPRESS #.
The recorder turns off automatically and “#” appears on the
display panel.
[1] : TITLE
21:00
25.12
22:00
1
– P1 –
[PROG] : EXIT
[Y/U] : CURSOR
[&] : DELETE
[0-9] : SELECT LETTERS
: OK
25.12 21:00 PR.1
– P1 –
[PROG] : EXIT
[Y/U] : CURSOR
[&] : DELETE
[0-9] : SELECT LETTERS
: OK
25.12 W
Before performing the following steps:
● Insert a cassette with the safety tab in place. The recorder will
come on automatically.
● Select the appropriate colour system (
੬
16).
Programme start time indicator
Programme start time indicator
Programme stop time indicator
HR-S6960AA_EN.fm Page 12 Monday, June 30, 2003 6:18 PM