Filter
Top Products
20
Preparation:
• Turn ON the TV and set to the video input mode.
• Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then
press VCR to select the VCR mode. (The VCR indicator will light)
Example: Preset the SAT1 on program position 5.
1
Press SET UP MENU.
Press or to select
CHANNEL SETUP. Then press
OK.
2
Press or to select CH
TUNING. Then press OK.
3
DEC OFF will blink. Press OK.
DEC OFF does not blink any
more. SEARCH will appear.
Note:
If you wish to store the
PREMIERE manually, the
decoder must have been
connected as on the lower of p.11.
During DEC OFF is blinking, press
.
DEC ON will blink now.
Press OK.
4
Press (rising frequency) or
(falling frequency) once. The
search starts. It stops at each
broadcast automatically (" "
change to " 4 "). Press or
repeatedly until the SAT1
appears. Only in case of receiving
of the weak broadcast (drifting
picture), search dose not stop. If
you want to stop, press / or
/ .
CH TUNING
CHANNEL SETUP
CHANNEL MAPPING
SELECT :
ENTER
:OK
MENU
EXIT
:
TIMER REC SET
ATS (AUTO TUNING SYSTEM)
VCR EXTENSION
CHANNEL SETUP
SYSTEM SETUP
SELECT :
ENTER : OK
MENU
EXIT
:
VCR SETUP
Manual TV station presetting
ATS stores the broadcast automatically.
However if you do the ATS under
unfavorable receiving conditions,
some broadcasts happen to be not
finded by ATS. For these broadcasts,
you can store also by manual.
Note:
Occasionally, the auto search might catch
a weak signal and stop. If the TV station
signal is weak, you shouldn't store this
station.
In that case restart the auto search using
or .
CH 1VPS
ARD
OK
OK
:
MENU
EXIT :
DEC OFF
SELECT :
CH 1
SEARCH :
/ F. TUNE :
MENU
EXIT
:
DEC OFF
2A73501AE(16-21) 4/17/02, 8:26 PM20