Filter
Top Products
Remote control buttons and functions
Adjust the volume
Press the buttons to adjust the volume.
The volume indicator appears and the volume changes as
you press the buttons.
Muting the sound
Press the (muting) button to turn off the
sound.
Pressing the (muting) button again restores the previous
volume level.
Watch images from external equipment
Use the AV button:
Press the
button to choose an EXT
terminal.
Displaying the source information
You can display the source information and current time on
Press the (information) button to display the
source information.
(information) button changes the display as
follows:
or
Signal source
01
O
VIDEO-1
TV
VIDEO-1
• The source information and current time switched by
(information) button.
__ : __
No display
• The source type :
TV/VIDEO-1/VIDEO-2/PC
AV
the screen.
i
i
Pressing the
i
• When watching videos, an incorrect current time
is sometime displayed.
To use the Programme number 0:
When the TV and VCR are connected only by the Aerial
cable, choosing the Programme number 0 allows you to
view images from the VCR. Set the VCR RF channel to
the Programme number 0 manually. For details, see
"MANUAL" on page 21.
• In PC mode, the current time will not be displayed
• If the programme being watched does not have Teletext
transmission, only a box will be displayed at the same
location.
In the PC mode:
If following message appears, the power lamp blinks in
amber and the TV goes in to reduced power mode.
- "NO SIGNAL"
- "CABLE NO INSERT"
- "OUT OF RANGE"
See "Troubleshooting" on page 30 for detials of this messages.
11
VIDEO-1
PC
VIDEO-2
TV mode
EXT modes
Last
program
number