Filter
Top Products
16
AV28CH1EUS&EUB / LCT1139-001A-U / English
PICTURE FEATURES
PICTURE FEATURESPICTURE FEATURES
PICTURE FEATURES
To display the PICTURE FEATURES menu:
1 Press the
a
button to display MENU
(main menu).
2 Press the
6
button to choose PICTURE
FEATURES, and press the
a
button.
■
■■
■
DIGITAL VNR
DIGITAL VNRDIGITAL VNR
DIGITAL VNR
The DIGITAL VNR function cuts down the amount of noise in
the original picture.
You can choose from the three DIGITAL VNR function set-
tings of AUTO, MIN and MAX.
Note:
•
If you set the DIGITAL VNR effect too high it can make the
picture less sharp. It is recommended to use the AUTO
setting if you can.
1
Press the 6 buttons to choose DIGITAL
VNR.
2
Press the 5 buttons to choose a setting.
AUTO:
The TV will automatically adjust the level of the DIGITAL
VNR effect to match the amount of noise in the picture,
giving you the best possible picture.
MIN:
The level of the DIGITAL VNR effect is set to the mini-
mum. If you set the DIGITAL VNR function to AUTO but
feel that the sharpness of the original picture has not
been reproduced fully, change the setting from AUTO to
MIN.
• The MIN setting is not suitable for low-quality pictures
which contain a lot of noise.
MAX:
The level of the DIGITAL VNR effect is set to the maxi-
mum. If you set the DIGITAL VNR function to AUTO but
still notice some noise, change the setting from AUTO to
MAX.
• The MAX setting is not suitable for high-quality pictures
which contain very little noise.
3
Press the
a
button to complete the set-
ting.
The menu disappears.
■
■■
■
COLOUR SYSTEM
COLOUR SYSTEMCOLOUR SYSTEM
COLOUR SYSTEM
The colour system is chosen automatically. However, if the
picture is not clear or no colour appears, choose the colour
system manually.
1
Press the
6
buttons to choose COLOUR
SYSTEM. Then press the
a
button.
The Sub-menu of the COLOUR SYSTEM function ap-
pears.
2
Press the 5 buttons to choose the ap-
propriate colour system.
PAL:
PAL system
SECAM:
SECAM system
NTSC 3.58:
NTSC 3.58 MHz system
NTSC 4.43:
NTSC 4.43 MHz system
AUTO:
This function detects a colour system from the input sig-
nal. Only when you are viewing a picture from Pro-
gramme number PR 0 (AV), or EXT terminal, you can
choose using the AUTO function.
3
Press the
a
button to complete the set-
ting.
The menu disappears.
Note:
•
The AUTO function may not function properly if you
have poor signal quality. If the picture is abnormal in
the AUTO function, choose another colour system
manually.
•
When in the Programme numbers PR 0 (AV) to PR
99, you cannot choose NTSC 3.58 or NTSC 4.43.
D0015-EN
DIGITAL VNR
COLOUR SYSTEM
4:3 AUTO ASPECT
AUTO
BACK
PICTURE FEATURES
TV OK
TV OK
BACK
D0016-EN
COLOUR SYSTEM
PAL
AV28CH1EU_Eng.book Page 16 Thursday, December 20, 2001 9:00 AM