Filter
Top Products
Connections
Connecting to AV Compu-Link III
JVC’s AV Compu Link III feature makes playing video tapes totally automatic. Simply insert a
pre-recorded tape* into your JVC-brand VCR and the VCR will automatically turn on and begin
playback. At the same time, using the AV Compu Link, the VCR sends a signal to the television
telling it to turn on and switch to the proper video input to watch a video tape.
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you wish
to connect. If it is not, contact an authorized JVC Service Center for part # EWP 805-012.
• AV Compu Link III can only be used with JVC-brand products.
To Connect: Plug one end of the AV Compu Link cable into the AV Compu Link input on your
VCR or other Compu Link device. Plug the other end of the AV Compu Link cable into the AV
Compu Link input at the rear of the television.
Notes:
* In order for the VCR playback to begin automatically, the recording tabs must be removed
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR’s P
LAY button.
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has “A Code/B Code Remote Control Switching” (see your VCR’s
instruction book), using VCR A Code will switch the TV to input 1. If you use Input 1 for
video input from your cable box, use VCR B Code to select the TV Video Input 2.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the HiFi’s connection instructions for detailed connection information.
• AV COMPU LINK III is compatible with all JVC AV COMPU LINK III devices
• The AV-56WP30 or AV-48WP30 can also receive Compu-Link signals from a DVD player.
For details on operating a DVD player with AV Compu Link, please see your DVD player’s
owners manual.
18
AV
COMPULINK III
IN
IN
V
L
R
OUT
OUT
VCR
AV
Compu
Link
Swap