Filter
Top Products
Operation
57
ENGLISH
Adjustments and settings in the menu (continued)
Clear Motion Drive
It improves video images with fast movements to produce clear video images with little
residual image retention.
This cannot be set when the PC Signal/3D Signal and "[2-3] 2D/3D" are ON.
Moreover, it may happen that the image is distorted in some scenes, or light and dark
ashes occur. In this case, please choose "Off", etc., and then a setting of your choice.
Settings: Off, Mode 1, Mode 2, Mode 3, Mode 4, Inverse Telecine [Off]
Off
Off
Mode 1
Black insertion weak
Mode 2
Black interpolation strong
Mode 3
Interpolation weak
Mode 4
Interpolation strong
Film Motion
With 60i/60p signals, e.g of TV-broadcast and DVDs, original 24 frame video image
footage is changed to a 24 frame display.
(*) 24p will not function.
CMD Demo
It is possible to conrm the effect of the setting of Mode 3 and Mode 4 of the Clear motion
drive. Upon pressing the button "OK", it will be displayed on all sides of a screen in the
center split into two parts. Finally, it will turn to "Off”. It cannot be set for PC and 3D
signals.
Settings: Left, right, top, Bottom, Off [Off]
Left The left screen displays a demonstration of the Clear motion drive.
Right The right screen displays a demonstration of the Clear motion drive.
Top The upper screen displays a demo of the Clear motion drive.
Bottom The screen below displays a demo of the Clear motion drive.
Off The Demo of the Clear motion drive is turned off.
MPC Level
Adjust the effect of resolution sense caused by increase in resolution of image display.
Please adjust the image noise according to your requirement.
(*) When the "picture mode" is "lm" and "THX", the default value will be "1".
(*) Cannot adjust if input signal is 3D or "2D to 3D conversion" is "ON".
(*) Cannot adjust when the setting of "Clear Motion Drive" is "Mode 1" or "Mode 2".
Settings: 0 to 3 [2]
Lens Aperture
Adjusts the amount with which the optical iris is squeezed. A setting of 0 means fully
opened.
Settings: (Dark) -15 to 0 (bright) [0]
Lamp Power
It is possible to change the brightness of the lamp.
(*) If continually used with "High", the lamp will become dark earlier.
(*) The more one lets the interior temperature of the device rise due to generation of heat,
the less the level of tolerance against high temperatures.
(*) For about 60 seconds after the lamp is lit, the lamp cannot be switched off.
(*) This will be "High" when the "Picture Mode” is set to "3D".
90
70
(*) This will be "High" when the "Picture Mode” is set to "3D", "Film" and "Cinema".
X
7
30
Settings: Normal, High [Normal]
Normal
High
Normally this setting is chosen.(160W drive)
In a bright room, when the video is hard to see, this setting is chosen.(220W drive)
User Name Edit
MENU
BACK
>
>
Name
User 1
Clear
All Clear OK
\}{][><
)(
~
|
;:
?=/-+*&%$#"!
^.,0987654321
zyxwvytsrqpon
lkjihgfedcba
YXWVUTSRQPON
MLKJIHGFEDCBA
Z
m
@
Exit
Back
Select
Operate
Picture Adjust
SPACE
Select cursor
Character list
Input cursor
90
70