JVC DLA-X30 TV Cables User Manual


 
Operation
69
ENGLISH
Pixel Adjust
Adjust(Fine)
Red
H 1 20/20
V 1 5 / 5
Color A.
GAMMA
PIC.
COLOR.
COLOR.
Select
Operate
BACK
BACK
TEMP
P.FILE.
ADJ.
A. Area
Color P.
ADJUST.
Pixel Adjust
Whole Adjust (Fine)
Red
H 1 20/20
V 1 5 / 5
Color A.
GAMMA
PIC.
COLOR.
COLOR.
Select
Operate
BACK
BACK
TEMP
P.FILE.
ADJ.
A. Area
Color P.
ADJUST.
Pixel Adjust
Whole Adjust (Fine)
Red
H 1 20/20
V 1 5 / 5
Color A.
GAMMA
PIC.
COLOR.
COLOR.
Select
Operate
BACK
BACK
TEMP
P.FILE.
ADJ.
A. Area
Color P.
ADJUST.
Vercital
H (Horizontal)
When both H (horizontal direction) and V (vertical direction) show a maximum overall screen error of 31,
even if the adjust setting is less than this, you may not congure an adjustment setting that is larger than the
displayed setting. Furthermore, when the minimum overall screen error is -31, even if the adjust setting is
greater than this, you may not congure an adjustment setting that is larger than the displayed setting.
This shows the maximum and minimum
overall screen error.(Max)/(Min)
Remote Control
Operation Guide
Adjust setting
Adjustments and settings in the menu (continued)
See Pixel Adjust Flow and Operation: Adjust(Fine)
After making overall adjustment for error across the entire screen, proceed to ne-tuning. Press the [COLOR
TEMP] button on the remote control to display the [Adjust(Fine) Window]. Also, from the main menu, set the
[Adjust Area] to [All] and select [Adjust Color] and [Adjust Pattern], then move the cursor to [Adjust (Fine)]
and press the [OK] button on the remote control to display the adjust pattern and the ne tune window.
(*) The range of adjustment may narrow depending on the adjust amount of the entire screen.
Adjust(Fine) window
Adjust Pattern
You can use the [UP], [DOWN],
[LEFT], and [RIGHT] buttons to
change position.
Pixel adjust setting
Adjust Color
Press the [OK] button on the remote control to enter the adjust operation mode. Use the [UP], [DOWN],
[LEFT], and [RIGHT] buttons to move and adjust pixels in the vertical and horizontal directions across the
entire screen. The adjustment settings appear in the center of the Adjust (Fine) window. Use the [BACK]
button to exit the adjust operation mode.
Adjust(Fine) window
(Reference page: 68)