Filter
Top Products
Masterpage:Right0
EN 25
Filename [DR-MH30EU_04Name.fm]
Page 25 Thursday, 3 June 2004 10:46
SAT CONTROL SET
The following procedure is required if you receive satellite channels
through a satellite receiver. Approximately 20 seconds before the
VIDEO Plus+ timer programming (੬ pg. 46) or Manual Timer
programming (੬ pg. 48) starts, the unit sets its input mode to “L-2”
and automatically switches the satellite receiver’s channels using
the provided Satellite Controller.
Installing Satellite Controller
1 Place the Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
2 Fix securely using the adhesive strip attached on the back of the
Satellite Controller.
3 Be sure to connect the unit’s L-2 IN/DECODER connector to the
satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4 Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Setting Satellite Receiver’s Brand And Channel
After installation, set the satellite receiver’s brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
1 Turn on the satellite receiver’s power.
2 Press SET UP to access the Main Menu screen.
3 Press we to select “INITIAL SET UP”, then press ENTER.
4 Press we to select “TUNER
SET”, then press ENTER.
5 Press rt w e to select “SAT
CONTROL SET”, then press
ENTER.
6 Press rt to select “BRAND”,
then press ENTER.
7 Press rt to select the brand
code from the list on page 26, then press ENTER.
● If the unit is in playback or recording mode, you cannot set the brand
code.
8 Press rt to select “PROGRAMME”, then press ENTER.
9 Press rt to select one of the channel positions on the satellite
receiver, then press ENTER.
● You can select the channel position between 1 to 999.
10 Press rt to select “TEST”,
then press ENTER. The unit enters
the Test mode.
Satellite Receiver Control Setting
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Transm itte r
21-pin SCART cable
(provided)
SAT CONTROLL-2 IN/DECODER
Your unit
Satellite Controller
(provided)
Satellite receiver
Back of unit
rtwe
ENTER
SET UP
CABLE/DBS
DVDTV
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
13
12
11
PRESS [SET UP] TO EXIT
ENTER
SELECT
EXIT
SET UP
SELECT WITH [ ] THEN PRESS [ENTER]
CLOCK SET
AUTO CH SET
GUIDE PROG SET
MANUAL CH SET
TUNER SET
DVD VIDEO SET UP INITIAL SET UPFUNCTION SET UPHDD/DVD SET UP
SAT CONTROL SET
PRESS [SET UP] TO EXIT
ENTER
SELECT
EXIT
SET UP
SELECT WITH [ ] THEN PRESS [ENTER]
INITIAL SET UP > SAT CONTROL SET
PROGRAMME
BRAND
12
73
TEST
DR-MH30EU_00.book Page 25 Thursday, June 3, 2004 11:00 AM