Filter
Top Products
Masterpage:Right0
EN 17
Filename [MV5SEK_05Name.fm]
Page 17 Wednesday, 31 August 2005 19:58
INITIAL SETTINGS
Auto Channel Set/Auto Clock Set/Auto Guide Program
Number Set
1 Press 1 to turn on the unit. The AUTO SET/T-V LINK display
appears on the TV screen.
2 Press rt to select “AUTO
SET”, then press ENTER. The
AUTO SET screen will appear,
and the unit automatically
performs Auto Channel Set.
● When Auto Channel Set is
completed, “PLEASE WAIT” will
be displayed for about 90
seconds, since channel data is
exchanged between the DVD
deck and the VHS deck. No operation will be done during this time.
A
TTENTION:
● When you have connected the
unit to a TV offering T-V Link via a
fully-wired 21-pin SCART cable
(੬ pg. 15) and the TV is turned
on, the unit automatically
performs the Preset Download
(੬ pg. 18) even if you select
“AUTO SET” for Auto Set Up
function.
NOTES:
● In areas where no TV station transmits a PDC (Programme Delivery
Control) signal, the unit can perform neither Auto Clock Set nor Auto
Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP while Auto Set
Up is in progress, Auto Set Up will be interrupted; be sure to turn off
the unit power once and try again from step 1.
● Auto Clock Set may not function properly depending on the reception
condition.
Auto Set Up
After the 1 button on the unit or remote control is pressed for
the first time to turn on the unit, the Auto Set Up function sets the
tuner channels, clock and Guide Program numbers
automatically.
Before starting, make sure of the following:
● The TV aerial cable should be connected to the unit.
● The unit’s AC power cord should be connected to a AC outlet.
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
ENTER
DVD
VHS
SET UP
SELECT WITH [CURSORS]
THEN PRESS [ENTER]
OK
SELECT
SET UP
INITIAL SET UP
AUTO SET
INITIAL SET UP / CHANNEL SET
T-V LINK
EXIT
SELECT WITH [CURSORS]
THEN PRESS [ENTER]
OK
SELECT
SET UP
INITIAL SET UP
AUTO SET
INITIAL SET UP / CHANNEL SET
T-V LINK
AUTO SET
PLEASE WAIT...
CANCEL
EXIT
A
TTENTION:
Once you have performed Auto Set Up, even if the unit’s memory
backup has expired, all the stored stations and their Guide
Program numbers remain in the unit’s memory and the unit will
not perform Auto Set Up again. The unit only performs Auto
Clock Set when the unit is turned on.
If you have moved to a different area, perform each setting as
required.
● Tuner setting (੬ pg. 84)
● Clock setting (੬ pg. 88)
If a new station starts broadcasting in your area, perform tunesr
setting. (੬ pg. 84)
After “Auto Set Up” is completed, perform “Monitor Set (DVD
Deck Only)” on page 21.
MV5SEK_00.book Page 17 Wednesday, August 31, 2005 7:58 PM