Filter
Top Products
Filename [MV5SEK_12RemoSys.fm]
Masterpage:Left0
76 EN
Page 76 Wednesday, 31 August 2005 19:58
SYSTEM CONNECTIONS
Connect the satellite receiver to the [L-2 IN/DECODER] connector,
then connect the [L-1 IN/OUT] connector to the TV’s connector.
NOTES:
● Set “L-2 SELECT” to “VIDEO/RGB” or “S-VIDEO/RGB”. (੬ pg. 45)
● You can use the Automatic Satellite Programme Recording function
(੬ pg. 36) with this connection. (DVD deck only)
● To record a programme via the satellite receiver, select L-2 mode by
pressing PR +/– so that “L-2” appears on the front display panel.
● For details, refer to the instruction manual of the satellite receiver.
The [L-2 IN/DECODER] connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
1 Set “L-2 SELECT” to “DECODER”. (੬ pg. 45)
2 Connect your unit’s [L-2 IN/DECODER] connector to the
decoder’s 21-pin SCART connector using a 21-pin SCART cable.
Connecting To A Satellite Receiver
IMPORTANT
When you set “L-2 SELECT” to “SAT VIDEO/RGB” (੬ pg. 45), it
is possible to view a satellite broadcast with the TV set to its AV
mode even if the unit is turned off. When the unit is in Stop mode
or recording, press TV/VIDEO on the remote control to turn off
the video indicator ( ) on the unit.
● If you turn on the unit when the satellite receiver’s power is off,
nothing appears on the TV screen. In this case, turn on the satellite
receiver, or set the TV to its TV mode, or press TV/VIDEO on the
remote control to set the unit to the AV mode.
Outdoor unit
Satellite cable
Satellite receiver
Aerial
TV aerial cable
TV
ANTENNA OUT
ANTENNA IN
Connecting/Using A Decoder (DVD
Deck Only)
TV
RF cable (provided)
TV aerial cable
L-1 IN/OUT
L-2 IN/
DECODER
Decoder
MV5SEK_00.book Page 76 Wednesday, August 31, 2005 7:58 PM