Filter
Top Products
Filename [MV5SEK_12RemoSys.fm]
Masterpage:Left0
74 EN
Page 74 Wednesday, 31 August 2005 19:58
REMOTE CONTROL
Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four codes
(1, 2, 3 or 4). The remote control is preset to send 3 code signals
because your unit is initially set to respond to 3 code signals. You
can easily modify your unit to respond to 1, 2 or 4 code signals.
● Keep pressing SET UP down during step 1.
1 Press the number button “1” for 1, “2” for 2, “3” for 3 or “4”
for 4 to change the remote control code, then press ENTER.
2 Press 1 on the unit to turn off the unit.
3 Press 4 on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4 Press 8 on the remote control to change the unit’s code. The
code currently set on the remote control blinks on the front display
panel for approximately 5 seconds, and is applied to the unit.
NOTE:
Even when “POWER SAVE” is set to “ON” (੬ pg. 79), it is possible to
change the remote code.
Remote Control Functions
● Slide the TV/DVD switch to DVD.
ENTER
SET UP
1 – 4
VHS/DVD
DVDVHS
REC
VHS DVDDUBBING
PR
DV IN
STANDBY/ON
S-VIDEO VIDEO AUDIO
MV5SEK_00.book Page 74 Wednesday, August 31, 2005 7:58 PM