JVC E9770ED/1VMN DVD VCR Combo User Manual


 
21
Getting Started
EN
Move
You can replace two channels.
1 In stop mode, press [SET UP].
2 Select “Advanced Setting Menu”
using [Cursor U / D], then press
[ENTER].
If it has already appeared, proceed to step 3.
3 Select “Channel” using
[Cursor U / D], then press [ENTER].
4 Select “Move” using [Cursor U / D],
then press [ENTER].
5 Select the position number of which
you want to change the channel
using [Cursor U / D], then press
[ENTER].
You cannot select a position number where
“– – –” appears next to the number, because
“Skip” is set to “ON” for that position number.
6 Move the channel to another
position number using
[Cursor U / D], then press [ENTER].
To move another channel, repeat steps 5 to 6.
7 Press [SET UP] to exit.
Setting the Clock
Auto Clock Setting
Channel Tuning must be set before setting Auto
Clock.
1 In stop mode, press [SET UP].
2 Select “Advanced Setting Menu”
using [Cursor U / D], then press
[ENTER].
If it has already appeared, proceed to step 3.
3 Select “Clock” using [Cursor U / D],
then press [ENTER].
4 Select “Auto Clock Setting” using
[Cursor U / D], then press [ENTER].
5 Select “ON” using [Cursor U / D],
then press [ENTER].
The current time will be set automatically.
6 Press [SET UP] to exit.
7 Press [STANDBY/ON /I] to turn off.
The Auto clock function is activated.
This unit will search for the time only when the
power is off. Leave the unit off for several minutes
to give it time to set the clock.
Hint
If you want to cancel “Auto Clock Setting,” select
“OFF” using [Cursor U / D], and then press
[ENTER] at step 5.
Note
The default setting of “Auto Clock Setting” is “OFF.”
The clock may set itself automatically after you
connect the antenna cable to the unit and plug in the
mains cable. In this case, the current time will
appear on the front panel display.
To set the clock automatically, the channel assigned
to “P01” must receive the PDC signal.
The clock cannot be set automatically if you are not
receiving a channel in your area that carries a time
signal. In this case, set the clock manually.
Once the auto clock setting is performed, the unit
will correct the current time by receiving PDC
broadcasts whenever you turn off the unit.
The unit will correct the current time automatically at
8:00, if the unit power is turned off.
Between 23:00 and 1:00, the Auto Clock function
will not operate even if the unit power is turned off.
Advanced Setting Menu
Playback
Recording
Display
Select Video
Clock
Channel
Disc
Easy Setting Menu
Clock
Advanced Setting Menu
Playback
Recording
Display
Select Video
Clock
Channel
Disc
Easy Setting Menu
Clock
E9770ED_EN.book Page 21 Wednesday, August 3, 2005 6:35 PM