Filter
Top Products
VCR Functions
65
EN
Accidental erasure prevention
To prevent accidental recording on a recorded
cassette, remove its record tab. To record on it later,
cover the hole with cellophane tape.
One-Touch Timer Recording
This feature allows you to set the recording length
simply by pressing [VCR REC I].
1 Turn on the unit and insert a
recordable tape.
Make sure that the TV input is set on the unit.
2 Press [VCR].
3 Select the recording speed using
[REC SPEED]. (See page 64.)
4 Select the desired channel to record
using [PR +/
-
] or [the Number
buttons].
5 Press [VCR REC I] repeatedly until
the desired recording time (30
minutes to 8 hours) appears on the
TV screen.
One-touch timer recording will start.
• When the unit reaches the specified time, it will be
turned off automatically.
• To change the recording length during one-touch
timer recording, press [VCR REC I] repeatedly
until the desired length appears.
• To cancel one-touch timer recording within the
specified time, press [STOP S].
Hint
• The remaining recording time will appear on the TV
screen during one-touch timer recording. Press
[ON SCREEN] to see it on the TV screen.
Note
• If VCR one-touch timer recording is completed
during DVD playback or recording, the VCR will be
in stop mode and the DVD keeps the current mode.
• You cannot use the pause function during one-touch
timer recording.
• When one-touch timer recording is finished and the
power is turned off, the unit will switch to the timer-
standby mode automatically if a timer recording has
been programmed. Press [TIMER
] to cancel the
timer-standby mode to use the unit continuously.
Search
Index Search
1 Press [VCR].
2 Press [VCR SEARCH] so that the
index search menu appears.
3 Enter the number of recordings you
wish to skip using [the Number
buttons] within 30 seconds.
4 Press [FWD f] or [REV r] to start
index search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After index search, the VCR will play back the
tape automatically.
Note
• This function is not available during recording.
• Every time a tape is recorded, an index mark is
written on the tape.
Time Search
This feature allows you to go to a specific point on a
tape by entering the exact amount of time you wish to
skip in order to reach the point.
1 Press [VCR].
2 Press [VCR SEARCH] repeatedly so
that the time search menu appears.
3 Enter your desired time to skip using
[the Number buttons] within 30
seconds.
4 Press [FWD f] or [REV r] to start
time search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After time search, the unit will play back the tape
automatically.
Note
• This function is not available during recording.
•Press [STOP S] to stop the search.
• If the tape reaches the end during a Search, this unit
will cancel the search and rewind the tape.
Record tab
VCRVCR
0:30
8:00 7:30
1:00
(Normal Recording)
VCRVCR
VCRVCR
E9770ED_EN.book Page 65 Wednesday, August 3, 2005 6:35 PM