Filter
Top Products
34
XV-N318S/GNT0042-001A/English
A
d
d
i
t
i
o
n
a
l
i
n
f
o
r
m
a
t
i
o
n
Troubleshooting
Power
Power does not come on.
\ Power plug is not inserted securely. Plug in securely.
Operation
“REGION CODE ERROR!” is shown on the TV screen.
\ Region code of the inserted disc does not match the player.
Check the region code of the disc printed on the disc jacket.
Operation is not possible.
\ Microcomputer malfunction due to lightning or static electricity.
Turn off the power and unplug the power cord, then connect
the power cord again.
\ Moisture condensation caused by a sudden change of
temperature or humidity. Turn off the power, then turn it on a
few hours later.
\ The disc does not allow the operation, or an unplayable disc is
inserted. Check and replace the disc (see page 2).
[LOCK] is displayed on the display window and the disc tray
does not open.
\ When you press 0 while pressing down 7 on the player in
standby mode, the tray lock function is activated. The disc tray
cannot be opened or closed in this status. To release this
status, press 0 while pressing down 7 on the player in
standby mode.
Picture
Picture is noisy.
\ The player is connected to a VCR directly and the copyguard
function is activated. Connect the player so that the picture
signal flows directly to the TV.
\ With some discs, the picture may be blurred when [PICTURE
SOURCE] is set to [FILM] or [AUTO]. Set [PICTURE
SOURCE] to [VIDEO (NORMAL)] or [VIDEO (ACTIVE)].
Picture is distorted when using COMPONENT VIDEO OUT or
S-VIDEO output jack(s).
\ Both the component connection and S-video connection are
made. Disconnect the unused one.
No picture is displayed on the TV screen or the screen is
blurred or divided into two parts.
\ The player is in the progressive scanning mode though it is
connected to a TV via the VIDEO or S-VIDEO jack. Observe
the display window. If [P] is turned on, the player is in the
progressive scanning mode.
Set the VIDEO SIGNAL SELECTOR on the rear panel to
“NTSC 525i/p REMOTE” and make the Progressive scanning
mode inactive by using the VFP - PROGRESSIVE SCAN
button (see page 5).
Audio
DVD VIDEO disc playback sound level is lower than TV
broadcast sound level.
\ Set the [D.RANGE CONTROL] preference to [TV MODE] (see
page 30).
Analog audio output is distorted.
\ Set the [OUTPUT LEVEL] preference to [LOW] (see page 30).
MP3/JPEG/MPEG-4
No sound and/or no picture comes out.
\ MP3/MPEG-4 disc is recorded with the “packet writing (UDF
file).” It cannot be played.
\ Check the files you want to play back.
Files (tracks) are not played in the recorded order.
\ This player plays the files in the alphabetic order. So, the
playback order can vary.
MPEG-4 files cannot be played back.
\ The format of the file is not asf.
KARAOKE
The KARAOKE function cannot be turned on.
\ You cannot turn on the KARAOKE function while playing back
an MP3 disc.
The musical key cannot be shifted.
\ Please connect the player using the AUDIO OUT (LEFT/
RIGHT) jacks.
The multichannel playback cannot be made.
\ The KARAOKE function is turned on.
The sound from the microphone(s) does not come out.
\ To output the signal from the MIC jack(s), connect the player
using the AUDIO OUT (LEFT/RIGHT) jacks (see page 24).
XV-N318S(USUBUGUX).book Page 34 Tuesday, May 11, 2004 5:54 PM