Filter
Top Products
three-step quick start10
before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the batteries into
the Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Turn on the TV
T
V
P
R
+
T
V
P
R
–
T
V
–
T
V
+
TV
0000
STOP
FIN
M
E
N
U
O
K
TV/VCR
DAILY/QTDN.
VPS/PDC
AUX
?
WEEKLY/HEBDO
PROG
30 SEC
– –:– –
AUDIO
1
. , /
ABC
JKLGHI MNO
PQRS TUV
]
WXYZ
DEF
2
3
4
6
5
7
8
9
0
DATE
START
DEBUT
PR
2
4
1
3
E
N
T
E
R
/
E
N
T
R
E
E
EXPRESS
P
R
+
OK
3
E
N
T
E
R
/
E
N
T
R
E
E
– –:– –
O
TE PR
Three-Step Quick Start
For Step , be sure to perform either of the methods:
Auto Setup or Preset Download.
Auto Setup
START AUTO SETUP
Press the o button. If ‘Auto’ appears on the display panel, press O (or E).
what will happen? The display panel on the front of the VCR will show the
word ‘Auto’. Do not press any button on the VCR or the Remote Control.
note If you have connected both the RF cable and the fully-wired 21-pin SCART
cable, and if your TV offers T-VLink, etc., and the TV is turned on, the VCR
automatically performs the Preset Download (੬ pg. 11) even if you select ‘Auto’
for Auto Setup function.
The VCR is automatically setting up the tuner
channels, clock, the VIDEO Plus+ assigned Guide
Program numbers and the video channel. This only
happens the first time that the VCR is turned on.
rf and scart connection If you have chosen to
connect the VCR to the TV with both the RF Cable
and a 21-pin SCART Cable (not provided) and the
TV set is in its AV mode (see the TV manual), you
will see the following information displayed on
your TV screen:
SELECT THE VIDEO CHANNEL
When
Auto Setup has finished, you will see the following display panel on your VCR:
rf cable only If you have only used the RF
Cable to connect the VCR to the TV, you will see
this display. The number is the channel on the TV that the
Auto Setup has chosen
to be the video channel. In the example, we have presumed that channel 36 is
vacant and have set the VCR to 36:
Now tune the TV set to channel 36 (refer to TV manual if necessary);
you should see two vertical white bars appear on the TV screen. If
the bars do not appear or are not clear, choose another vacant
channel and try again. If you cannot obtain the vertical white bars
on any channel between 22 and 69, consult your local JVC dealer.
rf and scart connection If you have chosen
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided), you need to press the
PR button
on the Remote Control until the figure reads ‘– –’. This is because you will use the
TV in AV mode to view video pictures and therefore do not need a dedicated video
channel.
AUTO SET
PLEASE WAIT
[MENU]: EXIT
Auto Setup is running: don’t
touch any buttons
Your TV screen during Auto Setup if SCART is used