JVC HR-J246EK VCR User Manual


 
15
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG or ( or £). “ 1” or
£ 1” is displayed on screen and search begins in
the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG once.
When the specified index code is located, playback
begins automatically.
Current position
Index number
%
%
%
AB C D E F
–2 –1 1 2 3
£ 2
Counter Memory
Returns to the counter reading of “0:00:00” to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press C. (COUNTER) RESET during playback at a point
you wish to locate later. The counter reads “0:00:00”.
Then press C.MEMORY, and “M” appears in front of the
counter digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
To cancel Counter Memory, press C.MEMORY again.
1
7
3
8
¡
123
456
7
/
8
0
9
4
2
1
3
C.MEMORY
C. RESET
FF
REW
STOP
PUSH JOG