JVC HR-J246EK VCR User Manual


 
4
INSTALLING YOUR NEW RECORDER
Basic Connections
RF Cable (provided)
CONNECT RECORDER TO
MAINS
4
Plug the end of the mains power cord into a mains
outlet.
Mains outlet
Mains Power
Cord
21-pin SCART Cable (not provided)
Back of TV
21-pin AV input connector (SCART)
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COM-
PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
FORMED.
Aerial connector
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in “Specifications” ( pg. 49).
SITUATE RECORDER
2
Place the recorder on a stable, flat surface.
CONNECT RECORDER TO
TV
3
The connection method you use depends on the type of
TV you have.
RF CONNECTION
To Connect To A TV With NO 21-pin AV input
connector (SCART) . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
on the rear panel of the recorder.
c– Connect the provided RF cable between the RF
OUT jack on the rear panel of the recorder and the
TV’s aerial connector.
Before operating the recorder, make sure the TV’s
channel is set to the VIDEO channel ( pg. 6).
AV CONNECTION
To Connect To A TV with 21-pin AV input connector
(SCART) . . .
a– Connect the aerial, recorder and TV as per “RF
CONNECTION”.
b– Connect an optional SCART cable between the
AV1 IN/OUT socket on the rear panel of the
recorder and the TV’s 21-pin AV input connector
(SCART).
Before operating the recorder, make sure the TV is set to
the VIDEO (or AV) mode.