Filter
Top Products
26
G-Code Timer
Programming
TIMER RECORDING
Before G-Code Timer programming, see "G-Code Setup" on
page 9.
During G-Code and on-screen timer programming, the Illumi-
Guide feature tells you which button on the remote control
must be pressed next by lighting it up. To use this feature, with
the TV/VCR switch set to "VCR", press ILLUMI GUIDE before
performing step 2. (MENU, REW, PLAY, FF light up at this time.)
If you aren't going to use the Illumi-Guide feature, go directly to
step 1.
∞ 5
6
q
When Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
● If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
12
45
3
6
8
0
7
9
OK
ILLUMI GUIDE
LOAD A CASSETTE
1
Make sure the record safety tab is present.
● The VCR’s power comes on automatically.
● If you’re watching on channel 3 or 4, press TV/VIDEO
to select the VIDEO mode. VIDEO is displayed on the
front display panel.
ACCESS G-CODE SCREEN
2
Press MENU on the remote
control.
● The clock must be set in
order to access the G-
Code screen. If you
haven’t set the clock, the
Main Menu screen
appears when you press
MENU. Refer to page 5 for the clock setting proce-
dure.
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), CANCEL and MENU.
ENTER G-CODE NUMBER
3
Press the appropriate NUMBER keys to enter the G-
Code number printed in the TV listings for the TV
program you wish to record.
● To make corrections, press CANCEL and input the
correct G-Code number.
● If the G-Code number you input is incorrect,
"ERROR" may appear on the screen to advise you of
the error. This happens when the G-Code number is
for a program which has already passed. "ERROR" is
displayed for about 4 seconds and the G-Code screen
reappears (step 2).
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), CANCEL and MENU.
G-CODE
PRESS NUMBER KEY(0-9)
PRESS (MENU) TO MAIN MENU
OK
CANCEL
TV/VCR
MENU
TV/VIDEO
NUMBER